資料介紹
The state diagram (Figure 3.) shows the modes the nRF24L01 can operate in and how they are accessed.
The nRF24L01 is undefined until the VDD becomes 1.9V or higher. When this happens nRF24L01 enters
the Power on reset state where it remains in reset until it enters the Power Down mode. Even when the
nRF24L01 enters Power Down mode the MCU can control the chip through the SPI and the Chip Enable
(CE) pin Three types of states are used in the state diagram. “Recommended operating mode” is a state
that is used during normal operation. “Possible operating mode” is a state that is allowed to use, but it is
not used during normal operation. “Transition state” is a time limited state used during start up of the oscillator
and settling of the PLL.
The nRF24L01 is undefined until the VDD becomes 1.9V or higher. When this happens nRF24L01 enters
the Power on reset state where it remains in reset until it enters the Power Down mode. Even when the
nRF24L01 enters Power Down mode the MCU can control the chip through the SPI and the Chip Enable
(CE) pin Three types of states are used in the state diagram. “Recommended operating mode” is a state
that is used during normal operation. “Possible operating mode” is a state that is allowed to use, but it is
not used during normal operation. “Transition state” is a time limited state used during start up of the oscillator
and settling of the PLL.
下載該資料的人也在下載
下載該資料的人還在閱讀
更多 >
- 基于nRF24L01的通用無線通信模塊設計案例
- 基于nRF24L01的無線通信系統設計
- 基于arm11的嵌入式linux中nrf24l01驅動的實現
- 單片無線收發器芯片NRF24L01 PCB原理圖下載 0次下載
- NRF24L01的模塊資料和C語言程序和使用與開發攻略合集免費下載 42次下載
- nRF24L01無線2.4G通信模塊的詳細研究資料說明
- nRF24L01無線模塊使用教程之經典使用程序詳細資料合集免費下載 153次下載
- nRF24L01相關知識詳述 27次下載
- NRF24L01程序 25次下載
- nRF24L01模塊引腳 0次下載
- NRF24l01 程序 34次下載
- NRF24L01編程心得 0次下載
- 基于nRF24L01的數據無線傳輸系統的設計與實現 78次下載
- 基于nRF24L01的通用無線通信模塊設計 64次下載
- NRF24l01無線232通信數據手冊 4次下載
- nRF24L01無線通訊模塊的驅動設計與實現 3524次閱讀
- stm32 24l01按鍵 改 發射頻率 3404次閱讀
- 微雪電子NRF24L01 RF Board 2.4G無線模塊簡介 3075次閱讀
- 如何通過STM32驅動nRF24L01發送數據 7777次閱讀
- 如何將芯片設置為發射模式(NRF24L01為例) 3826次閱讀
- 基于nRF24L01的無線USB控制系統 4990次閱讀
- 基于STM32F103和nRF24L01的近程無線數傳系統設計 2709次閱讀
- 基于STC89C52和nRF24L01的智能小車設計 8526次閱讀
- 基于nRF24L01的無線門禁控制系統的設計與實現 3318次閱讀
- 一種DSP和nRF24L01的無線環境監測系統的設計 2507次閱讀
- nrf24l01無線模塊傳輸距離分析 3.5w次閱讀
- 基于BOA和nRF24L01的智能家居系統 2823次閱讀
- 無線模塊nrf24l01中文資料_引腳圖及引腳定義_電路原理及實例 18.9w次閱讀
- nRF24L01無線模塊的傳輸速度及距離 3.7w次閱讀
- nRF24L01寄存器地址與說明 1.1w次閱讀
下載排行
本周
- 1TC358743XBG評估板參考手冊
- 1.36 MB | 330次下載 | 免費
- 2開關電源基礎知識
- 5.73 MB | 11次下載 | 免費
- 3嵌入式linux-聊天程序設計
- 0.60 MB | 3次下載 | 免費
- 4DIY動手組裝LED電子顯示屏
- 0.98 MB | 3次下載 | 免費
- 5基于FPGA的C8051F單片機開發板設計
- 0.70 MB | 2次下載 | 免費
- 651單片機窗簾控制器仿真程序
- 1.93 MB | 2次下載 | 免費
- 751單片機PM2.5檢測系統程序
- 0.83 MB | 2次下載 | 免費
- 8基于51單片機的RGB調色燈程序仿真
- 0.86 MB | 2次下載 | 免費
本月
- 1OrCAD10.5下載OrCAD10.5中文版軟件
- 0.00 MB | 234315次下載 | 免費
- 2555集成電路應用800例(新編版)
- 0.00 MB | 33566次下載 | 免費
- 3接口電路圖大全
- 未知 | 30323次下載 | 免費
- 4開關電源設計實例指南
- 未知 | 21549次下載 | 免費
- 5電氣工程師手冊免費下載(新編第二版pdf電子書)
- 0.00 MB | 15349次下載 | 免費
- 6數字電路基礎pdf(下載)
- 未知 | 13750次下載 | 免費
- 7電子制作實例集錦 下載
- 未知 | 8113次下載 | 免費
- 8《LED驅動電路設計》 溫德爾著
- 0.00 MB | 6656次下載 | 免費
總榜
- 1matlab軟件下載入口
- 未知 | 935054次下載 | 免費
- 2protel99se軟件下載(可英文版轉中文版)
- 78.1 MB | 537798次下載 | 免費
- 3MATLAB 7.1 下載 (含軟件介紹)
- 未知 | 420027次下載 | 免費
- 4OrCAD10.5下載OrCAD10.5中文版軟件
- 0.00 MB | 234315次下載 | 免費
- 5Altium DXP2002下載入口
- 未知 | 233046次下載 | 免費
- 6電路仿真軟件multisim 10.0免費下載
- 340992 | 191186次下載 | 免費
- 7十天學會AVR單片機與C語言視頻教程 下載
- 158M | 183279次下載 | 免費
- 8proe5.0野火版下載(中文版免費下載)
- 未知 | 138040次下載 | 免費
評論
查看更多